Policy Management show Commands ! 129
Chapter 5: Monitoring Policy Management
! Field descriptions related to policies
! Subinterface number—Location of the subinterface that carries the VLAN
traffic
! Administrative status—Operational state that you configured for this
interface: up or down
! VLAN ID—Domain number of the VLAN
! In Bytes—Number of bytes received on the VLAN subinterface
! In Packets—Sum of all unicast, broadcast, and multicast packets received
on the VLAN or S-VLAN subinterface
! In Errors—Value is always 0 (zero)
! In Discards—Value is always 0 (zero)
! Out Bytes—Number of bytes sent on the VLAN or stacked VLAN (S-VLAN)
subinterface
! Out Packets—Number of packets sent on the VLAN or S-VLAN subinterface
! Out Errors—Value is always 0 (zero)
! Out Discards—Value is always 0 (zero)
! VLAN policy—Type and name of the VLAN policy
! Example
host1#show interfaces fastEthernet 1/0.1
FastEthernet1/0.1 is Up, Administrative status is Up
VLAN ID: 100
In: Bytes 4156, Packets 30
Errors 0, Discards 0
Out: Bytes 6406, Packets 45
Errors 0, Discards 0
VLAN policy input vlanPol1
classifier-group vlan20 entry 1
5 packets, 730 bytes
filter
show ip interface
! Use to display information about an IP interface (including policy list statistics).
! Field descriptions related to policy management only
! Network Protocols—Protocols configured on the interface
! Internet address—IP address of the interface
! Broadcast address—Broadcast address used by the interface
! Operational MTU—Operational maximum transmission unit (MTU) for
packets sent on this interface
! Administrative MTU—Administrative maximum transmission unit for
packets sent on this interface
! Operational speed—Speed known to the IP layer in bits per second; equal
to the administrative speed if configured, otherwise inherited from the
lower layer
To Next Page
Loading...
