Juniper E Series

JUNOSe 7.2.x Policy Management Configuration Guide
142 ! Policy Management show Commands
mark profile D
forward
Parent group: X, parent-group Z
rate-limit-profile X
Parent group: Z
rate-limit-profile Z
Referenced by interface(s):
SERIAL4/0 input policy, statistics disabled, virtual-router default
SERIAL4/1 input policy, statistics disabled, virtual-router default
Referenced by profile(s):
No profile references
show rate-limit-profile
! Use to display information about rate-limit profiles.
! Field descriptions
! Rate-Limit-Profile—Create a rate limit policy
! Profile Name—Name of the rate-limit profile
! Profile Type—One-rate, two-rate, or hierarchical profile
! Reference count—Number of policy lists that reference this rate-limit
profile
! Color-aware—Color-aware action (yes or no) taken for profile
! Committed rate—Target rate for the traffic, in bits per second
! Committed burst—Amount of bandwidth allocated to accommodate bursty
traffic, in bytes
! Excess burst—Amount of bandwidth allocated to accommodate a packet in
progress when the rate is in excess of the burst, in bytes
! Peak rate—Amount of bandwidth allocated to accommodate traffic flow in
excess of the committed rate, in bits per second
! Peak burst—Amount of bandwidth allocated to accommodate bursty traffic
in excess of the peak rate, in bytes
! Mask—Value of mask applied to ToS byte in IP packet header
! Committed rate action—Policy action (drop, transmit, or mark) taken when
traffic flow does not exceed the committed rate
! Conformed rate action—Policy action (drop, transmit, or mark) taken when
traffic flow exceeds the committed rate but remains below the peak rate
! Exceeded rate action—Policy action (drop, transmit, or mark) taken when
traffic flow exceeds the peak rate
! atm-cell-mode—Whether the ATM cell tax is used in rate calculations,
enabled or disabled.