Juniper E Series

Policy Management show Commands ! 143
Chapter 5: Monitoring Policy Management
! Example
host1#show rate-limit-profile
Rate Limit Profile Table
---- ----- ------- -----
IP Rate-Limit-Profile: rlp
Profile Type: one-rate
Reference count: 0
Committed rate: 0
Committed burst: 8192
Excess burst: 0
Mask: 255
Committed rate action: transmit
Conformed rate action: transmit
Exceeded rate action: drop
IP Rate-Limit-Profile: rlp
Profile Type: two-rate hierarchical
Color-aware no
Reference count: 0
Committed rate: 0
Committed burst: 8192
Peak rate: 0
Peak burst: 8192
Mask: 255
Committed rate action: transmit unconditional
Conformed rate action: transmit conditional
Exceeded rate action: drop
L2TP Rate-Limit-Profile: L2tpRlp
Profile Type: two-rate
Reference count: 0
Committed rate: 0
Committed burst: 8192
Peak rate: 0
Peak burst: 8192
Committed rate action: transmit
Conformed rate action: transmit
Exceeded rate action: drop
show vlan subinterface
! Use to display information about a subinterface’s VLAN policy lists.
! Field descriptions
! Subinterface number—Location of the subinterface that carries the VLAN
traffic
! VLAN ID—Domain number of the VLAN
! VLAN policy—Type and name of the VLAN policy
! filter—Number of packets and bytes that have been policed by the policy
! Example
host1#show vlan subinterface fastEthernet 1/0.1
VLAN ID is 100
VLAN policy input vlanPol1
classifier-group claclVlanBos entry 1
5 packets, 730 bytes
filter