Juniper E Series

JUNOSe 7.2.x Policy Management Configuration Guide
182 ! Logging Packet Mirroring Information
! show mirror trap—Displays the status (enabled or disabled) of the secure
packet mirroring traps feature.
! show snmp trap—Displays configuration information about SNMP traps and
trap destinations, including secure packet mirroring traps.
Ta b l e 3 4 indicates the events that trigger secure packet mirroring traps and lists the
information sent in the trap for each event.
NOTE: See JUNOSe System Basics Configuration Guide, Chapter 4, Configuring SNMP
for information about the JUNOSe software’s SNMP support.
Table 34: Packet Mirroring SNMP Traps
Trap Information Sent Event that Triggers the Trap
A secure policy failed
during CoA-based or
RADIUS-initiated
packet mirroring
A secure policy
failed during CLI
trigger or CLI-based
packet mirroring
An interface with
secure policies
attached is deleted
An analyzer is
unreachable
Analyzer address – – –
!
Application name
!!
––
Configuration source
!!!
–
Data and time of event –
!! !
Error cause
!!
––
Error string
!!
––
Mirror ID
!
–
!(valid only if RADIUS is
the configuration source)
–
Mirroring direction – –
!
–
Secure policy name –
!!(valid only if CLI is the
configuration source)
–
Secure policy UID –
!!(valid only if RADIUS is
the configuration source)
–
Session ID
!
–
!(valid only if CLI is the
configuration source)
–
Trigger event
!!!
–
Trigger type
!!!
–
Username
!
–– –
Virtual router (0 for
L2TP)
!!!!