Juniper EX9200 Series

arp policer-template-name;
input policer-name;
output policer-name;
}
primary;
receive-options-packets;
receive-ttl-exceeded;
rpf-check {
fail-filter filter-name;
mode loose;
}
sampling {
(input | output | input output);
}
simple-filter {
input filter-name;
}
targeted-broadcast {
forward-and-send-to-re;
forward-only;
}
unnumbered-address interface-name <destination address>
<destination-profile profile-name> <preferred-source-address address>;
}
family inet6 {
address ipv6-address {
destination destination-address;
eui-64;
ndp ipv6-address <l2-interface interface-name> <(mac mac-address |
multicast-mac multicast-mac-address) <publish>>;
preferred;
primary;
vrrp-inet6-group group-number {
(accept-data | no-accept-data);
fast-interval milliseconds;
inet6-advertise-interval seconds;
(no-preempt; | ... the following preempt statement ...)
preempt {
hold-time seconds;
}
priority number;
track {
interface interface-name {
bandwidth-threshold bits-per-second priority-cost priority;
priority-cost priority;
}
priority-hold-time seconds;
route ip-address-prefix/prefix-length routing-instance instance-name
priority-cost priority;
}
virtual-inet6-address [ addresses ];
virtual-link-local-address ipv6-address;
vrrp-inherit-from {
active-group group-number;
55Copyright © 2013, Juniper Networks, Inc.
Chapter 4: Configuration Statements