EasyManuals Logo
Home>Juniper>Network Router>JUNOS OS 10.4

Juniper JUNOS OS 10.4 User Manual

Juniper JUNOS OS 10.4
200 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #144 background imageLoading...
Page #144 background image
Table 3: Monitor Ethernet Delay Command Parameters (continued)
DescriptionParameter RangeParameter
(Optional) Specifies the number of seconds to wait between frames. The
default is 1 second.
1–255 seconds
(default: 1)
wait time
If you attempt to monitor delays to a nonexistent MAC address, you must exit the
application manually using ^C:
user@host> monitor ethernet delay-measurement two-way 00:11:22:33:44:55
Two-way ETH-DM request to 00:11:22:33:44:55, Interface ge-5/2/9.0
^C
--- Delay measurement statistics ---
Packets transmitted: 10, Valid packets received: 0
Average delay: 0 usec, Average delay variation: 0 usec
Best case delay: 0 usec, Worst case delay: 0 usec
Related
Documentation
Ethernet OAM
Ethernet Frame Delay Measurements on page 119
Configuring MEP Interfaces to Support ETH-DM on page 122
Viewing ETH-DM Statistics on page 124
Configuring One-Way ETH-DM with Single-Tagged Interfaces on page 125
Configuring Two-Way ETH-DM with Single-Tagged Interfaces on page 130
Configuring ETH-DM with Untagged Interfaces on page 134
Viewing Ethernet Frame Delay Measurements Statistics
Once Ethernet frame delay measurement statistics have been collected, they can be
displayed.
To retrieve the last 100 Ethernet frame delay measurement statistics per remote MEP
or per CFM session, two types of show commands are provided:
For all OAM frame counters and Ethernet frame delay measurement statistics
For Ethernet frame delay measurement statistics only
To retrieve all Ethernet frame delay measurement statistics for a given session, use the
show oam ethernet connectivity-fault-management mep-statistics maintenance-domain
name maintenance-association name [local-mep identifier] [remote-mep identifier] [count
count] command.
To retrieve only Ethernet frame delay measurement statistics for a given session, use
the show oam ethernet connectivity-fault-management delay-statistics
maintenance-domain name maintenance-association name [local-mep identifier]
[remote-mep identifier] [count count] command.
Copyright © 2012, Juniper Networks, Inc.124
Junos OS 12.1 MX Series 3D Universal Edge Routers Solutions Guide

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Juniper JUNOS OS 10.4 and is the answer not in the manual?

Juniper JUNOS OS 10.4 Specifications

General IconGeneral
BrandJuniper
ModelJUNOS OS 10.4
CategoryNetwork Router
LanguageEnglish

Related product manuals