CHAPTER 35
Installation Safety Guidelines and
Warnings
•
M7i Chassis Lifting Guidelines on page 233
•
Installation Safety Warnings for Juniper Networks Devices on page 233
M7i Chassis Lifting Guidelines
The weight of a fully configured chassis is about 36.5 lb (16.6 kg). Observe the following
guidelines for lifting and moving the router:
•
Before moving the router, read the guidelines in “M7i Router Site Preparation Checklist”
on page 73 to verify that the intended site meets the specified power, environmental,
and clearance requirements.
•
If a lift cannot be used, one person can lift the router. Another person is required install
the mounting screws.
•
Before lifting or moving the router, disconnect all external cables.
•
As when lifting any heavy object, lift most of the weight with your legs rather than your
back. Keep your knees bent and your back relatively straight and avoid twisting your
body as you lift. Balance the load evenly and be sure that your footing is solid.
Related
Documentation
Installation Safety Warnings for Juniper Networks Devices on page 233•
Installation Safety Warnings for Juniper Networks Devices
Observe the following warnings before and during hardware equipment installation:
•
Intrabuilding Ports Warning on page 234
•
Installation Instructions Warning on page 234
•
Rack-Mounting Requirements and Warnings on page 234
•
Ramp Warning on page 238
233Copyright © 2019, Juniper Networks, Inc.
To Next Page
Loading...
Need help?
General
