To unpack the router:
1. Move the shipping crate to an ESD-approved staging area as close to the installation
site as possible, where you have enough room to remove the components from the
chassis. While the chassis is bolted to the shipping pallet, you can use a forklift or
pallet jack to move it.
NOTE: We recommend that all components be removed from the chassis
before installation.
2. Position the shipping crate with the arrows pointing up.
3. Open all the latches on the shipping crate.
4. Remove the front door of the shipping crate and set it aside.
NOTE: If you ordered a router transport kit, the shipping crate door is used
as a ramp to guide the MX2020 out of the crate.
5. Using a two-person team, slide the remainder of the shipping crate off the pallet (see
Figure 7 on page 16).
15Copyright © 2015, Juniper Networks, Inc.
Unpack the Router
To Next Page
Loading...
Need help?
General
