NOTE: Be sure to check out our Guided Setup: SRX300 Line Firewalls. Our Guided Setup picks up where this
Day One+ leaves off, providing step-by-step instructions on how to easily secure and validate your branch
location.
SRX300 Provisioning Options
It’s simple to provision and manage the SRX300 and other devices on your network. Choose the configuration tool that’s
right for you:
•
Junos CLI commands. In this guide we show you how to configure the SRX300 with CLI commands that leverage the
plug and play factory defaults.
•
J-Web, Juniper Networks GUI that is preinstalled on the SRX300. For information on performing initial configuration
using the J-Web setup wizard see Configure SRX Devices Using the J-Web Setup Wizard in the J-Web User Guide for
SRX Series Devices.
•
Juniper Sky™ Enterprise, Juniper Networks-hosted public cloud-based Software as a Service (SaaS) solution. You’ll need
to have a Juniper Sky Enterprise subscription service before you can use it to configure the SRX300. For more information,
check out the Juniper Sky Enterprise Getting Started Guide.
•
Contrail Service Orchestration (CSO). If you are using Junos OS Release 19.2 or earlier, you can use Juniper Networks
Network Service Controller to configure the SRX300 with ZTP. Network Service Controller is a component of CSO. See
Configure the Device Using ZTP with Juniper Networks Network Service Controller.
To use CSO, you’ll need an authentication code. See the Contrail Service Orchestration (CSO ) Deployment Guide.
Initial Configuration Using the CLI
IN THIS SECTION
Connect to the Serial Console Port | 7
Perform Initial Configuration | 8
Congratulations! Your SRX is Up and Running | 9
You can use the console port on the SRX to do the initial configuration. This section assumes you start from a factory
default configuration. See SRX300 Firewall Hardware Guide for details on the SRX300 factory default configuration.
6
To Next Page
Loading...
Need help?
General
Weight and Dimensions
