Machine settings
Maintenance actions
Optimal coffee quality depends on many factors. One important prerequisite is regular maintenance of your C8. Carry out the following
steps:
Maintenance action Daily If necessary Note
Empty the drip tray and coffee grounds
container and rinse with warm water
(The insert for the drip tray, including the drip
tray itself, and the coffee grounds container are
dishwasher-safe)
Z
Always empty the coffee grounds container when the
machine is switched on. This is the only way of resetting
the coffee grounds counter.
Clean the milk system (if heavily soiled, also
dismantle and rinse it)
Z
See chapter 7 ‘Maintenance – Cleaning the milk system’.
We recommend that you dismantle and rinse the profes-
sional fine foam frother once a week (see chapter 7
‘Maintenance – Dismantling and rinsing the dual spout’)
Rinse the milk pipe
Z
Rinse the water tank
Z
Wipe the surface of the machine with a clean,
soft, damp cloth (e.g. microfibre cloth)
Z
Changing milk pipe with connector HP1 approx. every
3 months
Change the interchangeable milk spout CX1 approx. every
3 months
Clean the inside of the water tank with a brush
Z
Clean the top and bottom of the cup grille
Z
Thoroughly clean the drip tray and coffee
grounds container
Z
Machine settings
On page 3 of the start screen, you will find the Menu (MENU) with the Maintenance programmes and Programme options for your C8.
Programme item Explanation
POWDER
Activate ground coffee mode to include specialities with ground coffee in the preparation options
MILK CLEANING
Clean the milk system on a daily basis if milk has been used to prepare the beverages
CLEANING
DESCALING
FILTER
Perform cleaning, descaling and a filter change as soon as the corresponding prompt appears
LANGUAGE
Set language
ACCESSORY
(only displayed if JURA Wi-Fi
Connect is being used)
Establish a wireless connection between your C8 and the Cool Control milk cooler or disconnect it
again
APP
(only displayed if JURA Wi-Fi
Connect is being used)
Wirelessly connect the C8 to the JURA app (J.O.E.®) or disconnect again (see chapter 3 ‘Preparing and
using for the first time – Establish Wi-Fi connection’)
WATER HARDNESS
Set the hardness of the water in order to prevent a build-up of limescale in your machine
(6 levels: 1-5/6-10/11-15/16-20/21-25/26-30°dH)
UNITS
Set the unit for the amount of water (ml or oz)
SWITCH-OFF TIME
Set the automatic switch-off time to save energy (switch-off after 30minutes or 1/2/4 hours after the
last action on the machine)
FACTORY SET.
Reset your C8 to factory settings (the machine then switches off)
EMPTY SYSTEM
Empty the system to protect the C8 from frost damage during transport (see chapter 10 ‘Transport and
environmentally friendly disposal – Transport/ Emptying the system’)
To Next Page
Loading...
Need help?
General
