Maintenance
T
Place the container under the dual spout and connect the milk pipe with the container.
E To connect the milk pipe to the container correctly, the pipe must be fitted with a HP connector.
T
Press the w button.
The milk system is cleaned.
The operation is interrupted, FRESH WATER
T
Rinse the container thoroughly and fill the front part with fresh water up to the upper mark.
T
Place the container back under the dual spout and reconnect the milk pipe with the container.
T
Press the w button.
The milk system will be rinsed with fresh water. The operation stops automatically.
Dismantling and rinsing the dual spout
If insufficient foam is produced when the milk is frothed or milk sprays out of the dual spout, the spout may be dirty. If this happens,
dismantle and rinse the dual spout.
E We recommend dismantling and rinsing the dual spout once a week.
T
Remove the milk pipe and rinse it thoroughly under running water.
T
Pull the cover of the dual spout forwards and off.
T
Remove the milk system from the dual spout.
T
Dismantle the milk system into its individual parts.