Jura E8 - Dismantling and Rinsing the Professional Fine Foam Frother

30
5 Maintenance
T Press the ‘Pc’ button.
T Press the
‘Clean the milk system’ button.
‘Clean the milk system’
T Press the ‘Start’ button.
T Press the
‘Next’ button.
‘Clean the milk system’ / ‘Milk system cleaner’
T Remove the milk pipe from the milk container or carton.
T Add milk system cleaner to the front part of the container
up to the bottom mark (indicated by 6).
T Then fill with water up to the upper mark.
T Place the container under the professional fine foam frother.
T If you are using the professional fine foam frother, set the
setting wheel to the Milk Foam position é.
T Connect the milk pipe to the container.
E To connect the milk pipe to the container correctly, the pipe
must be fitted with a connector.
T Press the
‘Next’ button.
‘Milk system is being cleaned’ appears and the professional
fine foam frother and the milk pipe are cleaned.
T During the first brief interruption, set the setting wheel of
the professional fine foam frother to the Milk position è.
‘Clean the milk system’ / ‘Fresh water’
T Rinse the container thoroughly and fill the front part with
8.5 oz (250 ml) of fresh water.
T Place this under the professional fine foam frother and
reconnect the milk pipe to the container.
T Press the
‘Next’ button.
‘Milk system is being cleaned’ appears and the professional
fine foam frother and the milk pipe are rinsed with fresh water.
The start screen is displayed.
To make sure the professional fine foam frother works properly, and
in the interests of hygiene, it must be dismantled and rinsed daily
if you have been preparing milk. Your JURA will not prompt you to
dismantle and rinse the professional fine foam frother.
T Remove the milk pipe and rinse it thoroughly under running
water.
6
é
è
6
é
è
Dismantling and rinsing
the professional fine
foam frother