Jura E8 - Rinsing and Cleaning Systems

29
5 Maintenance
In programming mode, you can set whether the milk system rinsing
is to be prompted 10 minutes after preparation or initiated
automatically (see Chapter 4 ‘Permanent settings in programming
mode – Milk system rinsing’).
After each milk preparation, the JURA prompts you to perform a milk
system rinse.
Precondition:
‘Rinse the milk system’ is displayed.
T Place a receptacle under the professional fine foam frother.
T Press the
‘Pc’ button.
T Press the
‘>’ button.
T Press the
‘Rinse the milk system’ button to start the rinse
operation.
‘Milk system is being rinsed’ appears and the professional
fine foam frother is rinsed. The operation stops automatically.
To ensure that the professional fine foam frother always works
properly, you must clean it daily when you have been preparing
milk.
Non-recommended cleaning agents will not optimally remove milk
residues. This may cause the cappuccino frother to become blocked
and fly off the machine. Discharge of hot steam.
T Use only original JURA milk system cleaner.
Harmful and irritating cleaning agent. Harmful if swallowed.
Irritating to eyes and skin.
T Keep children AWAY.
T Avoid contact with skin and eyes.
T After contact with skin, wash immediately with plenty of
water. In case of skin irritation, seek medical advice.
T After eye contact, immediately flush eyes with plenty of water
and seek medical advice.
T If swallowed, rinse mouth immediately and drink large
quantities of water. Do not induce vomiting. Seek medical
advice immediately and show label.
E JURA milk system cleaner is available from specialized dealers.
E To clean the milk system, use the container supplied.
Rinsing the professional
fine foam frother
é
è
Cleaning the professional
fine foam frother
J WARNING
J WARNING