Jura GIGA W10 - Dismantling and Rinsing the Dual Spout

7 Maintenance
24
T
 Touch the time area to open the Cockpit�
T
 Touch ‘Clean the milk system’�
T
 Touch ‘Next’�
‘Cleaning agent for milk system’ / ‘Connect the milk tube’
T
 Remove the milk pipe from the milk container or milk cooler�
T
 Pour one dosing unit of milk system cleaner into the container
for milk system cleaning�
T
 Place the container under the dual spout and connect the milk
pipe with the container�
E To connect the milk pipe to the container correctly, the pipe
must be fitted with a connector HP3�
T
 Slide the dual spout down to fix the container in place�
T
 Touch ‘Start’�
The dual spout and the milk pipe are cleaned�
The operation stops automatically�
If insufficient foam is produced when the milk is frothed or milk
sprays out of the dual spout, the spout may be dirty� If this happens,
dismantle and rinse the dual spout�
T
 Remove the milk pipe and rinse it thoroughly under running
water�
T
 Press the releasing devices and pull the cover of the dual spout
up and off�
6
Dismantling and rinsing the
dual spout