22
4 Permanent settings in programming mode
T Press the ‘Coffee’ button.
‘Coffee’
T Press the ‘Coffee strength’ button.
‘Coffee’ and the coffee strength is displayed.
T Press the ‘<’ or ‘>’ button to change the setting for the
coffee strength.
T Press the ‘Save’ button.
‘Saved’ appears briefly on the display.
‘Coffee’
T Press the ‘’ button for around 2 seconds to exit
programming mode.
In the program item ‘3/5’/ ‘Customise cup fill volume’ you can make
the following setting:
U
‘Active’: The function ‘Permanently setting the amount of
water for the cup size’ is activated. You can adjust the amount
of water to the cup size by pressing and holding the relevant
preparation button.
U
‘Inactive’: The function ‘Permanently setting the amount of
water for the cup size’ is deactivated. The amount of water
cannot be adjusted to the cup size by pressing and holding
the relevant preparation button.
Example:Proceed as follows to disable the function ‘Permanently
setting the amount of water for the cup size’.
T Press the ‘P’ button.
T Press the ‘>’ button several times until ‘3/5’ is displayed.
T Press the ‘Customise cup fill volume’ button.
‘Customise cup fill volume’
T Press the ‘Inactive’ button.
T Press the ‘Save’ button.
‘Saved’ appears briefly on the display.
‘3/5’
T Press the ‘’ button to exit programming mode.
Enable or disable setting
of cup volume
To Next Page
Loading...
Need help?
General
