24
4 Permanent settings in programming mode
By instructing your JURA to automatically switch itself off, you can
cut down your energy consumption. If this function is activated,
your JURA switches off automatically after the preset time following
the last action on the machine.
You can set the automatic switch-off to 15 minutes, 30 minutes
or 1–9hours.
T Press the ‘P’ button.
T Press the ‘>’ button several times until ‘4/5’ is displayed.
T Press the ‘Switch off after’ button.
‘Switch off after’
T Press the ‘<’ or ‘>’ button to change the switch-off time.
T Press the ‘Save’ button.
‘Saved’ appears briefly on the display.
‘4/5’
T Press the ‘’ button to exit programming mode.
The harder the water is, the more frequently the JURA needs to be
descaled. It is therefore important to set the water hardness
accurately.
The water hardness was set when the machine was first used. You
can change this setting at any time.
The total water hardness can be adjusted on a continuous scale
between 1°dH and 30°dH.
T Press the ‘P’ button.
T Press the ‘>’ button several times until ‘4/5’ is displayed.
T Press the ‘Water hardness’ button.
‘Water hardness’
T Press the ‘<’ or ‘>’ button to change the setting for the
water hardness.
T Press the ‘Save’ button.
‘Saved’ appears briefly on the display.
‘4/5’
T Press the ‘’ button to exit programming mode.
Automatic switch-off
Setting the water
hardness
To Next Page
Loading...
Need help?
General
