Juro WE8 - Regular Maintenance; Switching off the Machine

21
3 Daily operation
T Rinse the water tank with clean water.
T Clean the fine foam frother (see Chapter 5 ‘Maintenance –
Cleaning the milk system’).
T Remove the milk pipe and rinse it thoroughly under running
water.
T Dismantle and rinse the fine foam frother (see Chapter 5
‘Maintenance – Dismantling and rinsing the fine foam
frother’).
T Wipe the surface of the machine with a clean, soft, damp
cloth (e.g. microfiber cloth).
Carry out the following maintenance actions regularly or as
required:
U
In the interests of hygiene, we recommend changing the milk
pipe and interchangeable milk spout on a regular basis
(approximately every 3 months). Replacements are available
from specialized dealers.
U
Clean the inside of the water tank, e.g. with a brush. Further
information about the water tank is provided in these
instructions for use (see Chapter 5 ‘Maintenance – Descaling
the water tank’).
U
Traces of milk and coffee may stick to the top and bottom of
the cup platform. If this happens, clean the cup platform.
When the JURA is switched off, the system is automatically rinsed if
a specialty coffee has been prepared.
T Place one receptacle under the coffee spout and another
under the fine foam frother.
T Press the On/Off button Q.
E If milk has been prepared, you will be prompted to clean the
milk system (
‘Clean the milk system’). After 10 seconds the
switch-off process continues automatically.
E If milk has been prepared but you have not started milk
system cleaning, the milk system is rinsed first (
‘Milk system
is being rinsed’
).
‘Machine is rinsing’, the system rinses itself. The operation
stops automatically. Your JURA is switched off.
Regular maintenance
Switching off the
machine