31
5 Maintenance
T Press the ‘Clean the milk system’ button.
‘Clean the milk system’
T Press the ‘Start’ button.
T Press the
‘Next’ button.
‘Clean the milk system’ / ‘Milk system cleaner’
T Remove the milk pipe from the milk container or carton.
T Add milk system cleaner to the front part of the container
up to the bottom mark (indicated by 6).
T Then fill with water up to the upper mark.
T Place the container under the fine foam frother.
T Connect the milk pipe to the container.
E To connect the milk pipe to the container correctly, the pipe
must be fitted with a connector.
T Press the
‘Next’ button.
‘Milk system is being cleaned’ appears and the fine foam
frother and the milk pipe are cleaned.
‘Clean the milk system’ / ‘Fresh water’
T Rinse the container thoroughly and fill the front part with
fresh water up to the upper mark.
T Place this under the fine foam frother and reconnect the
milk pipe to the container.
T Press the
‘Next’ button.
‘Milk system is being cleaned’, the fine foam frother and the
milk pipe are rinsed with fresh water.
The operation stops automatically.
To make sure the fine foam frother works properly, and in the
interests of hygiene, it must be dismantled and rinsed daily if you
have been preparing milk. Your JURA will not prompt you to
dismantle and rinse the frother.
T Remove the milk pipe and rinse it thoroughly under running
water.
T Carefully remove the fine foam frother from the Connector
System
©
by twisting slightly.
6
6
Dismantling and rinsing
the fine foam frother
To Next Page
Loading...
Need help?
General