Juro WE8 - System Configuration and Management

26
4 Permanent settings in programming mode
T Press the ‘Hot water’ button.
The lock is closed. Hot water preparation is now disabled.
T Press the
‘’ button for around 2 seconds to exit program-
ming mode.
By instructing your JURA to automatically switch itself off, you can
cut down your energy consumption. If this function is activated,
your JURA switches off automatically after the preset time following
the last action on the machine.
You can set the automatic switch-off to 15minutes, 30minutes or
1–9hours.
T Press the
‘Pc’ button.
T Press the
‘>’ button several times until ‘4/6’ is displayed.
T Press the
‘Switch off after’ button.
‘Switch off after’
T Press the ‘<’ or ‘>’ button to change the switch-off time.
T Press the
‘Save’ button.
‘Saved’ appears briefly on the display.
‘4/6’
T Press the ‘’ button to exit programming mode.
In the program item
‘4/6’ / ‘Rinse the milk system’ you can make the
following settings:
U
‘Manual’: You are prompted to perform milk system rinsing
10minutes after preparation of a specialty coffee with milk.
U
‘Automatic’: The milk system rinsing is automatically initiated
10minutes after preparation of a specialty coffee with milk.
Example:Proceed as follows to set the milk system rinsing to be
initiated automatically 10 minutes after the preparation.
T Press the
‘Pc’ button.
T Press the
‘>’ button several times until ‘4/6’ is displayed.
T Press the
‘Rinse the milk system’ button.
‘Rinse the milk system’
T Press the ‘Automatic’ button.
T Press the
‘Save’ button.
‘Saved’ appears briefly on the display.
‘4/6’
T Press the ‘’ button to exit programming mode.
Automatic switch-off
Milk system rinsing