JVC 1010MTH-SW-MT - Audio and Digital Output Configurations; Disc Recording Audio and Dynamic Range Control; Down Mix and Digital Output Formats

v
DISC RECORDING AUDIO
For changing the settings of audio to be recorded to the disc
when in the AF, AN, AE or AL mode.
Setting
Values
Description
AUTO Records “Stereo”, “Surround” or “Dual
broadcast” audio sounds as they are.
FIXED Records “Stereo” and “Surround” sounds in
“Stereo”. “Dual broadcast” audio sounds are
recorded as they are.
Memo:
v
Surround sounds of a title become stereo sounds when re-
encode dubbing is performed.
Audio
.
1-
4'6740
#7&+1
&;0#/+%4#0)'%10641.
10
10
&190/+:
56'4'1
&+)+6#.176
&8+0#7&+15'66+0)
56'4'1
$&/+:5170&
':+6
5'672
5'.'%6
m
DYNAMIC RANGE CONTROL
For setting the dynamic range compression ratio (ratio
between the maximum and minimum volume) during Dolby
Digital playback.
Setting Values Description
AUTO Perform compression only for Dolby
TrueHD.
OFF Not compressed.
ON Perform maximum compression.
Memo:
v
Setting to “OFF” may produce the same effects as the “ON”
mode for some discs.
v
Performing compression allows even the slightest sound to
be heard clearly.
v
There may be differences in the effect depending on the
disc used.
m
DOWN MIX
For setting whether to output analog audio.
Setting Values Description
STEREO Use this setting when connecting an
audio amplifier or TV.
DOLBY
SURROUND
Use this setting when connecting an
amplifier that supports Dolby
Surround.
m
DIGITAL OUT
Set this item according to the device connected to the digital
audio output terminal (optical digital).
v
PCM DOWN SAMPLING
For specifying settings on sampling frequency conversion.
Setting
Values
Description
OFF Sampling frequency is not converted.
ON Audio recorded at a sampling frequency of
96 kHz or 88.2 kHz is converted to 48 kHz
and 44.1 kHz respectively.
Memo:
v
Setting to “OFF” may produce the same effects as the “ON”
mode for some discs.
v
Dolby Digital
For setting audio output to “BITSTREAM” or “PCM”.
Setting Values Description
BITSTREAM Use this setting when connecting a
device that is able to decode “Dolby
Digital”.
PCM Audio input will be changed and output as
“PCM”.
Use this setting when connecting a
device that is unable to decode “Dolby
Digital”.
v
Dolby Digital Plus/TrueHD
For setting audio output to “BITSTREAM” or “PCM”.
Setting
Values
Description
BITSTREAM Use this setting when connecting a
device that is able to decode “Dolby
Digital Plus/TrueHD”.
PCM Audio input will be changed and output as
“PCM”.
Use this setting when connecting a
device that is unable to decode “Dolby
Digital Plus/TrueHD”.
v
DTS
For setting audio output to “BITSTREAM” or “PCM”.
Setting Values Description
BITSTREAM Use this setting when connecting a
device that is able to decode “DTS”.
PCM Audio input will be changed and output as
“PCM”.
Use this setting when connecting a
device that is unable to decode “DTS”.
Settings Menu
78