While showing a playback picture on tile TV, you can select
the preset picture tone, or adjust it and store your ow'n
preference.
To select a preset picture tone
1 Activate VFP.
On the TV screen
Select a preset pictm'e tone.
NORMAL Normally select this.
CINEMA Suitable for a movie source.
USERI/USER2 You can adjust parameters and can
store the settings (see the next
column).
3 Finish setting.
VFP
To adjust the picture tone
1 Select "USERI" or "USER2."
. Follow' steps 1 and 2 explained above.
2 Select a parameter you want to adjust.
GAMMA Adjustif the neutral color is bright or
dark. The brightness of dal'k and
bright portions is maintained
( 3 to +3).
BRIGHTNESS Adjust flthe picture is bright or dark
as a whole ( 8 to +8).
CONTRAST Adjust if the far and near position is
unnatural ( 7 to +7).
SATURATION Adjust i*the picture is whitish or
blackish ( 7 to +7).
TINT Adjust if the huulan skin color is
unnatural ( 7 to +7).
SHARPNESS Adjust if the picture is indistinct
( 8 to +g).
3 Adjust the parameter.
4 Repeat steps 2to 3 to adjust other parameters.
,.5 Finish setting.
VFP
18
To Next Page
Loading...
