6 Check if the drivers are correctly installed.
1 Open the Control Panel on your PC: Select [Start] -+
[Settings] -'_ [Control Panel]
2 Click [System] -+ [Hardware] -+ [Device Manager]
-+ [Sound, video and game controllers] and
[Universal Serial Bus controllers]
• The following window appears, and you can check
whether the drivers are installed.
. 4¸4¸4¸4¸4¸4¸4¸4¸4¸4¸4¸¸¸i¸ 444& ?);
--#
* The installed drivers can be show'll only when the System is
COlmected to the PC.
To play backsoundson the PC
Refer to the manuals supplied with the sound reproduction
application installed in the PC.
= Microsoft ¢3, Windows ¢) 98SE, Windows @ Me, Windows @
2000 and Windows ¢) XP are registered trademarks of
Microsoft corporation.
Pla i tr mothe Exter. !EqU
IMPORTANT
Torn the power off to all components before
connections.
Always set volulne to VOL M1N when connecting or
disconnecting the other equiplnent.
By connecting an external audio equipment or game console,
you can enjoy the dynamic sound with this system.
* When enjoying a video game with your game console
connected to this System, connect this System and your
TV/monitor with the composite video cable (see page 6).
To connect game console
(front panel)
CA_E,A.× Red
White
Yellow
Game console
To connect audio equipment
(front panel)
_,ME//,L,X Red
Audio equipment
To select other external equipment for the
source
AUX NIG2TR_.PG _3G-; TI;0 R__]
To select external audio equipment as the source, select
"AUX".
To select game console as the source, select "G-I RPG",
"G-2 SPORT", "G-3 ACTION" or "G-4 NIGHT".
. While selecting GAME/AUX for the source, the sound
mode and 3D Phonic do not take effect.
To enjoy powerful game sound
When you select "G-I RPG", "G-2 SPORT", "G-3
ACTION" or "G-4 NIGHT", you can enjoy the sound effect
suitable for the genre or scene of the game.
G-I RPG For RPG.
G-2 SPORT For sport game.
G-3 ACTION For action game.
G-4 NIGHT For enjoying powerfld game sound
with low sound level.
* The video signals from the external equipment connected
to GAME/AUX jack are output as composite video signal.
The system does not output S-video signals for these
external equipment.
15