JVC CA-HXD77

PICTURESOURCE
You can obtain optimal picture quality by selecting an
appropriate option picture source type (either video source
or fihn source).
Select one of the Ibllowing:
AUTO: Normally select this.
When playing back a disc containing both video
and fihn sources, the System automatically
changes the processing to match it to the picture
type (fibn or video source) of the current chapter.
FILM: To play a fihn source disc.
VIDEO: To play a video source disc.
libido)
SCREENSAVER
You can activate or deactivate screen saver while operating
the built-in disc player.
Select one of the Ibllowing:
ON: The picture on the TV becomes dark when no
operation is done for about 5 minutes.
OFF: To cancel the screen saver.
FiLETYPE
If both audio tracks (MP3/WMA files) and still picture
(JPEG files) are recorded on a disc, you can select which to
play.
Select one of the lbllowing:
AUDIO: To play MP3/WMA files.
STILL PICTURE: To play JPEG files.
[] AUDIOSet up Menu
You can adjust the sound settings of the System.
DiGiTALAUDIOOUTPUT
When using the digital output terminal on the rear, set this
correctly according to the connected component.
Select one of the I_llowing:
PCM ONLY: To connect to a linear PCM digital
equipment such as an MD recorder.
DOLBY DIGITAL To connect to a Dolby Digital decoder
/PCM: or an amplifier with a built-in Dolby
Digital decoder.
STREAM/PCM: To connect to a DTS decoder or an
amplifier with a built-in DTS decoder.
, See also "OPTICAL D1G1TAL OUTPUT Signals" on
page 43.
DOWNNiX
When playing a multi-channel DVD, the System converts
the signals into 2 channels.
Down mix setting is effective for the speaker output (and
digital audio output if "DIG1TAL AUD10 OUTPUT" is set
to "PCM ONLY") from this System.
Select one of the l_llowing:
STERE(): To connect a conventional stereo
amplifier, receiver, MD player, TV, etc.
DOLBY To connect an amplifier with the Dolby
SURROUND: Pro Logic decoder.
37