- 6 -
Power cord important information
Caution:
Please use the power cord provided with this monitor in accordance with the table
below. If a power cord is not supplied with this product, please contact your dealer.
For all other cases, please use a power cord that matches the AC voltage of the power
outlet and has been approved by and complies with the safety standards of your
particular country. When you use this monitor for medical in North America, you
should use a North America Hospital Grade power cord.
Country U.S.A./Canada EU Japan
Plug Shape
or
Standard UL/CSA
VDE, Demko,
Nemko, BSI, etc.
PSE
Voltage 120 230 100
UK Responsible Person
JVCKENWOOD U.K. Limited
First Floor, Gleneagles, The Belfry, Colonial Way, Watford, Hertfordshire
WD24 4WH, UNITED KINGDOM
Warning
● This apparatus must be earthed because of Class I equipment.
● This apparatus is not a patient contact equipment.
● When using at 240 V in the United States, supply must be from center-tapped, 240 V,
single phase circuit.
● Consult your dealer about waste disposal.
● This apparatus shall not to be used in the vicinity of the patient, which is the space
with surfaces likely to be contacted by the patient or an attendant who can touch the
patient. This encloses a space within the room 1.83 m (6 feet) beyond the perimeter of
the bed in its intended location, and extending vertically 2.29 m (7-1/ 2 feet) above
the oor.
Equipment classication
● Type of protection against electric shock: Class I equipment
● Protection against harmful ingress of water: Ordinary Equipment (IPX0)-No
protection.
● Not suitable for use in the presence of ammable anesthetics or oxygen.
● Mode of operation: Continuous operation
To Next Page
Loading...
Need help?
General