Keystone
For
correcting any keystone distortion that occurs when the projector is installed at an angle with respect to the screen.
0
Vertical setting range: -16 to +16
* Increasing the value changes the aspect slightly.
*
This function cannot be used if “Pincushion” is set.
Pincushion
Corrects the geometric distortion that occurs when projecting on a curved screen.
0
Setting range: 0 to 16
* When
using the projector with the lens shifted in the vertical direction, the amount of distortion at the upper and lower
ends may be different and the curvature distortion may not be fully corrected.
* This function cannot be used if “Keystone” is set.
Aspect
The screen size of the projected image can be adjusted optimally according to the original screen size (aspect) that
has been input.
Æ “Adjusting the Screen Size (Aspect)” (P.
26)
Display Setup
Back Color
For setting the color of the background to “Blue” or “Black” when there is no signal input.
Menu Position
For setting the display position of the menu.
Signal Display
For setting the display of the input information to “On” or “Off”.
Setting Description
Off Not displayed.
On Shows the input terminal for 5 seconds when input is switched.
60
Adjust/Set
To Next Page
Loading...
Need help?
General
