Filename [MX1S_07HDD Operation.fm]
Masterpage:Left0
44 EN
Page 44 Saturday, 30 October 2004 16:18
BASIC OPERATIONS ON HDD DECK
1 Press VHS/HDD/DVD SELECT on the unit repeatedly or HDD
on the remote so that the HDD lamp lights up on the unit.
2 Press CH +/– or the number keys to select the channel you
wish to record.
3 Press REC MODE repeatedly to select the recording mode,
then press ENTER.
● Each time you press REC MODE, the recording mode changes as
follows:
XP ] SP ] LP ] EP ] FR60–FR360* ] FR420, FR480 ]
(Back to the beginning)
* The value is selectable from 1 to 6 hours in 5 minutes interval by
pressing we repeatedly after selecting “FR60–FR360”. To change the
value in 30 minutes interval, press and hold we.
● For details on the recording mode, see the right column.
4 Press 7 on the unit to start recording. Or while holding 7, press
4 on the remote control.
● The HDD recording lamp lights up on the unit.
5 Press 8 twice to stop recording.
● Pressing 8 once displays the confirmation message to stop
recording. Press 8 again to terminate recording.
NOTES:
● Continuous recording for over 48 hours is not possible.
● It is not possible to record on both DVD and HDD simultaneously.
Pause recording on HDD deck
It is not possible to pause recording. Pressing 9 initiates Live
Memory Playback.
However, it is still possible to pause recording only when recording
the channels of external sources (“L-1”, “F-1”, and “DV”). While
holding 7, press 9 on the remote. To resume recording, while
holding 7, press 4 on the remote.
No operation can be made with the buttons on the unit.
Recording Mode
MPEG2 format is used as recording format. As a guide for picture
quality, the “bps” unit is used to represent how much data can be
recorded per second. The larger this value is, the better the picture
quality becomes but more capacity is required for the recording.
Select XP or SP for programs where quick movement occurs, such
as sports programs, and LP or EP for talk shows, etc. with
relatively less movement.
● For details on FR mode, refer to “Free Rate Function” (墌 pg. 43)
NOTE:
The maximum recording time stated in the above table are the
approximate time under unused condition.
Basic Recording
● Turn on the unit.
● Turn on the TV and select the video channel (or AV mode).
● Slide the TV/CABLE/DBS/DVD switch to DVD.
TTENTION:
The HDD on the unit requires approximately 20 seconds to start up
after the unit has been turned on, during which no operation can be
made.
7
CH +/
8
VHS/HDD/DVD
SELECT
4
7
8
0-9
REC MODE
HDD
CH+/
-
9
CABLE/DBS
DVDTV
HDD Lamp
Recording
mode
Recording amount
(approx.)
Maximum recording
time (approx.)
XP 10 Mbps 18 hours
SP 5 Mbps 35 hours
LP 2.5 Mbps 70 hours
EP 1.6 Mbps 105 hours
FR60–FR360
(墌 pg. 43)
The amount varies
depending on the
selected time.
18 – 105 hours
FR480 147 hours
MX1S_00.book Page 44 Saturday, October 30, 2004 4:18 PM
To Next Page
Loading...
Need help?
General
