JVC DT-V1710CG - PREPARATION; Installing Input Cards

(No. 52152) 1-11
! INITIAL SETTING VALUE TABLE [MAIN MENU]
Setting Item Data / Variable range Initial setting value
! INITIAL SETTING VALUE TABLE [FRONT PANEL CONTROL]
Setting Item Data / Variable range Initial setting value
POWER ON / OFF OFF
INPUT SELECT INPUT A – F INPUT A
COLOR OFF
AREA MARKER
PULSE CROSS
ASPECT ON / OFF OFF
UNDER SCAN
SCREENS CHECK
DEGAUSS
VOLUME 00 – 50 10
CONTRAST
BRIGHT POTENTIOMETER Center click position
CHROMA
PHASE
APERTURE CONTROL
LEVEL 00 – 10 00
CONTROL FREQ. HIGH / LOW / OFF HIGH
SLOT CONDITION Type of boards installed in the rear panel slots.
INPUT A – F SLOT1 : INPUT A, B
SLOT2 : INPUT C, D
SLOT3 : INPUT E, F
sub menu POSITION LOWER / UPPER LOWER
AREA MARKER
MARKER SELECT OFF / LINE /S. HALF / HALF+L / S. BLK / BLK. +L OFF
ZOOM OFF / ON OFF
ASPECT SELECT 4 : 3 / 13 : 9 / 14 : 9 4 : 3
SAFEY AREA OFF / 80% / 88% / 90% OFF
R-MARKER SELECT OFF / LINE / S. HALF / HALF+L / S. BLK / BLK. +L OFF
R-ZOOM OFF / ON OFF
R-ASPECT SELECT 4 : 3 / 13 : 9 / 14 : 9 4 : 3
R-SAFETY AREA OFF / 80% / 88% / 90% 0FF
COLOR MATRIX SELECT : MANUAL / ITU601 or ITU709 NORMAL
[Example when MANUAL is set]
R-Y PHASE : 90/92/94/112 90
R/B GAIN : 0.56/0.68/0.79/0.86 0.86
G-Y PHASE : 236/240/244/253 244
G/B GAIN : 0.30/0.34/0.40/0.45 0.30