JVC GY-HM250ESB - Page 23

23
2
Select [Score Sync].
3
Select [Replica1].
4
Enter the address, username and
password.
●
Enter the address (e.g.: 192.168.0.1),
username (e.g.: jvc) and password (e.g.:
0000).
The address is the [IP Address]
displayed in the Status screen
(Network) of the camera recorder.
If the port number of the Web access
has been congured to a value other
than 80, enter the port number following
the address.
Example: If the port number of the Web
access of the address 192.168.0.1 has
been changed to 1234, the address
input eld should be 192.168.0.1:1234.
★ Do not register the camera recorder
(primary) on which you are conguring.
If you have done so, turn o the camera
recorder and then turn it on again.
* The username is “Login Name (Fixed)”
in the Network Settings → Web of the
camera recorder.
* The password is the same as that
congured in the “Login Password”.
5
Select [Save].
6
[The conguration is successful.]
If the connection is successful,
“Replica1 [address]” is displayed.
[The conguration is unsuccessful.]
If the connection is unsuccessful due
to incorrect settings etc., “Log-in failed.
[address]” is displayed.
7
Proceed to register Replica2 and
Replica3 as necessary.
Start to input the score once the setting is
completed.