JVC KD-BT11 - Page 24

ENGLISH
24
Indications Item
( : Initial)
Setting, [reference page]
CLOCK ADJ *
2
Clock adjustment
• AUTO
• OFF
: The built-in clock is automatically adjusted using the clock data
provided via the satellite radio channel.
: Cancels.
TIME ZONE *
2,
*
3
Time zone
— : Select your residential area from one of the time zones for clock
adjustment.
EASTERN, ATLANTIC, NEWFOUND, ALASKA, PACIFIC, MOUNTAIN,
CENTRAL
DST *
2,
*
3
Daylight savings
time
• DST ON
• DST OFF
: Activates daylight savings time if your residential area is subject to
DST.
: Cancels.
SID *
4
SIRIUS ID
— : Your SIRIUS identification number scrolls on the display 5 seconds
after “SID” is selected, [17].
DIMMER
Dimmer
• AUTO
• ON
• OFF
: Dims the display and button illumination when you turn on the
headlights.
: Activates dimmer.
: Cancels.
SCROLL *
5,
*
6
Scroll
• ONCE
• AUTO
• OFF
: Scrolls the displayed information once.
: Repeats scrolling (at 5-second intervals).
: Cancels.
• Pressing DISP for more than one second can scroll the display
regardless of the setting.
L/O MODE
Line output mode
• REAR
• SUB.W
: Select if the REAR LINE OUT terminals are used for connecting the rear
speakers (through an external amplifier).
: Select if the REAR LINE OUT terminals are used for connecting a
subwoofer (through an external amplifier).
SUB.W FREQ *
7
Subwoofer cutoff
frequency
• LOW
• MID
• HIGH
: Frequencies lower than 90 Hz are sent to the subwoofer.
: Frequencies lower than 135 Hz are sent to the subwoofer.
: Frequencies lower than 180 Hz are sent to the subwoofer.
SUB.W PHASE *
7
Subwoofer phase
• 180 DEG
• 0 DEG
: Select either “0 DEG” or “180 DEG” which reproduces a better sound.
*
2
Displayed only when SIRIUS Satellite radio or XM Satellite radio is connected.
*
3
Displayed only when “CLOCK ADJ” is set to “AUTO.”
*
4
Displayed only when SIRIUS Satellite radio is connected.
*
5
Some characters or symbols will not be shown correctly (or will be blanked) on the display.
*
6
Not applicable to HD Radio text scrolling.
*
7
Displayed only when “L/O MODE” is set to “SUB.W.”
EN22-29_KD-BT11[J]2.indd 24EN22-29_KD-BT11[J]2.indd 24 10/31/07 1:59:40 PM10/31/07 1:59:40 PM