JVC KD-R716 - Bluetooth Settings Configuration

18 ENGLISH
Setting item Selectable setting, [Initial: Underlined]
AUTO CNNCT • LAST
• OFF
: The connection is established automatically with the last
connected Bluetooth device when you turn on the unit.
: The unit does not connect the Bluetooth device
automatically. Connect the device manually. ( 14)
AUTO ANSWER
• ON
• OFF
: The unit answers the incoming calls automatically.
: The unit does not answer the calls automatically. Answer
the calls manually. (
15, 16)
MSG NOTICE
• ON
• OFF
: The unit informs you of the arrival of a message by
ringing and displaying “RCV MESSAGE.”
: The unit does not inform you of the arrival of a message.
MIC LEVEL —
: Adjust the volume of the microphone connected to the
unit. [ LEVEL 01/02/03 ]
NR/EC MODE
• ON
• OFF
: The unit adjusts the Noise Reduction and Echo
Cancelation of the microphone connected to the unit
for clearer sound.
: Cancels.
RING TONE
• IN UNIT
• IN PHONE
: The unit rings to alert you when a call/Text Message
comes in.
CALL: Select your preferred ring tone when a call
comes in. [ TONE 1/2/3 ]
MESSAGE: Select your preferred ring tone when a Text
Message comes in. [ TONE 1/2/3 ]
: The unit rings (using the connected phones’ ring tone)
to alert you when a call/Text Message comes in. (The
connected mobile phone rings if it does not support this
feature.)
P. BOOK SEL *
1
• PB IN PHONE
• PB IN UNIT
: The unit browses the phonebook of the connected
phone.
: The unit browses the phonebook registered in the unit.
P. BOOK WAIT — : You can copy the phonebook memory of a mobile
phone into the unit (via OPP).
Enter the PIN code to the unit to transfer the phonebook
into the unit. You can transfer a maximum of 400
numbers.
INITIALIZE
• YES
• NO
: Initialize all the Bluetooth settings (including stored
pairing, phonebook, and etc.).
: Cancels.
INFORMATION • MY BT NAME
• MY ADDRESS
• BT SW VER
• PH CNNT DEV *
2
• AU CNNT DEV *
2
: Shows the unit name.
: Shows address of USB Bluetooth Adapter.
: Shows the software version.
: Shows connected phone name.
: Shows connected audio device name.
*
1
Selectable only when the connected phone supports PBAP.
*
2
Displayed only when a Bluetooth phone/audio player is connected.
EN12-21_KD-R716_001A_f.indd 18EN12-21_KD-R716_001A_f.indd 18 12/17/09 3:04:07 PM12/17/09 3:04:07 PM