ENGLISH
8
Listening to the radio
1
Change the source to tuner.
Press the button repeatedly until the tuner frequency is displayed.
2
Select the band.
F(FM) 1 F2 F3
A(AM) 1
A2
3
Search for a station to listen—Auto Search.
When a station is tuned in, searching stops. To stop searching, press the same
button again.
• You can also search a station manually—Manual Search. Hold either one of
the buttons until “M” appears on the display, then press it repeatedly.
• When receiving an FM stereo broadcast with sufficient signal strength, the ST
indicator lights up on the display.
Improving the FM reception
When an FM stereo broadcast is hard to receive,
activate monaural mode for better reception.
On the Unit ONLY:
Reception improves, but stereo effect will be lost.
• The MONO indicator lights up on the display.
To restore the stereo effect, repeat the same
procedure to select “MONO OFF.” The MONO
indicator goes off.
To tune in FM stations only with
strong signals—LO/DX (Local/
Distance-extreme)
If received signals are weak, you may only hear
noises. You can make this unit detect only stations
with sufficient signal strength while searching for FM
stations.
On the Unit ONLY:
Only stations with sufficient signal strength will be
detected.
• The LO indicator lights up on the display.
To tune in to all receivable stations, repeat the
same procedure to select “DX.”
• The LO indicator goes off.
MONO ON
LOCAL
[Hold]
EN_KD-SV3706[US].indb 8EN_KD-SV3706[US].indb 8 08.12.11 3:10:03 PM08.12.11 3:10:03 PM
To Next Page
Loading...
Need help?
General
