23
ENGLISH
• When “CEQ LINK” is set to “LINK ON,”
The selected sound mode can be stored in
memory for the current source.
Each time you change to the same source, the
same sound mode is also recalled and shown
on the display. The C-EQ indicator also flashes.
• When “CEQ LINK” is set to “LINK OFF”
The selected sound mode effect applies to any
source.
Storing your own sound
adjustments
You can adjust the sound modes to your preference
and store your own adjustments in memory.
• There is a time limit in doing the following
procedure. If the setting is canceled before you
finish, start from step 1 again.
1
Call up the sound mode you want to
adjust.
The last selected sound mode is
recalled and applied to the
current sound.
3
Adjust the level.
4
Repeat steps 2 and 3 to adjust the
other items.
5
Repeat the same procedure to store
other sound modes.
To reset to the factory settings, repeat the
same procedure and reassign the preset values
listed in the table on page 22.
To decrease the level.
To increase the level.
Ex.: When you adjust “TRE”
Sound mode indicator flashes
Ex.: If you have selected “ROCK” previously
2
Select the item you want to adjust.
• See page 21 for details.
Equalization pattern changes as
you adjust the bass or treble.
EN21-23.KD-SX980[J]f.pm5 7/1/02, 3:22 PM23
To Next Page
Loading...
Need help?
General
