JVC KW-AV70BT - Precise Sound Adjustment; Adjusting Crossover Frequency

43
ENGLISH
Adjusting the crossover
frequency
1 On <AV Menu> screen:
2
3 Select the item to adjust, then make
adjustments.
Adjusts the subwoofer level.
Adjusts the crossover frequency.
Selects the phase for the subwoofer.*
Adjusts the crossover for front or rear speakers
(high pass filter).
Adjusts the crossover for subwoofer (low pass filter).
* Not selectable when <Freq> is set to <Through>.
Adjusting the sound precisely
1 Perform steps 1 and 2 of “Selecting a
preset sound mode,” then...
2 Select a band.
3 Adjust the sound.
Reset Changes level of Low/Mid/
High to 0.
Freq Selects frequency.
Q Adjusts the width of the
frequency.*
1
Bass Activates/deactivates bass.*
2
SW Level Adjusts subwoofer level.
The adjustments are overwritten if <User>
setting has been made ( page 42), and <User>
is activated.
• The adjustments are memorized until you
adjust sound again.
• To make adjustment for other bands, repeat
steps
2 and 3.
*
1
Fixed for “High” band.
*
2
Only for “Low” band.
EN_KW-AV70JJW.indb 43 11/12/13 13:09