JVC KW-M740BT - User Interface Setup

Setting Up
44
User Interface Setup
You can setup user interface parameters.
1
Press the [FNC] button.
 Popup menu appears.
2
Touch [ ].
 HOME screen appears.
3
Touch [ ].
 SETUP screen appears.
4
Touch [User Interface].
 User Interface screen appears.
5
Set each item as follows.
■ [Steering Remote Controller]
Sets the desired function in the steering
remote controller. See Learning function of
steering remote (P.45).
■ [Beep]
Turns the key touch tone on or off.
Default is “ON”.
■ [Language Select]
Selects a language.
■ [Touch Panel Adjust]
Adjust the sensing position of touch panel.
(P.44)
■ [Clock]
[GPS-SYNC ](Default): Synchronizes the clock
time with the GPS.
[Manual]: Sets the clock manually
■ [Time Zone]
Select the time zone.
■ [Clock Adjust]
If you select [Manual] for Clock, adjust the
date and time manually. (P.44)
■ [DISP Key]
Select the source screen displayed when
on the popup menu screen is pressed.
[NAV]: Switches to the navigation screen from
the connected navigation unit by pressing
the button. (P.41) (Not-covered areas:
Oceania)
[Mirroring] (Default): Switches to the App
screen from the connected iPod touch/
iPhone/Android device or Apple CarPlay
screen from the connected iPhone by
pressing the button. (P.14)
[OFF]: Displays the control screen of current
source.
Ñ Adjust the date and time
manually.
1
Touch [Clock] in the User Interface screen.
2
Select [Manual].
3
Touch [Time Zone] in the User Interface
screen.
4
Select the time zone.
5
Touch [Clock Adjust] in the User Interface
screen.
6
Adjust the date, then adjust the time.
7
Touch [Set].
Ñ Touch panel adjustment
1
Touch [Touch Panel Adjust] on the User
Interface screen.
 Touch Panel Adjust screen appears.
2
Follow the instruction on the screen and
long touch the center of each [ ].
1
2
!B5A-2304-00b_KWV-M_En.indb 44 2019/04/26 10:56