JVC KW-M740BT - Display Setup

Setting Up
46
■ [Software Information]
Check the software version of this unit.
(P.46)
■ [Open Source Licenses]
Displays the open source licenses.
■ [Initialise]
Touch [Initialise] and then touch [Ye s ] to set
all the settings to the initial default settings.
• Audio SETUP Memory is not initialized.
Ñ Software Information
Check the software version of this unit.
1
Touch [Software Information] in the
Special screen.
2
Confirm the software version.
NOTE
• For how to update the software, see the relevant
update procedure manual which comes with the
software.
Display Setup
1
Press the [FNC] button.
 Popup menu appears.
2
Touch [ ].
 HOME screen appears.
3
Touch [ ].
 SETUP screen appears.
4
Touch [Display].
 Display screen appears.
5
Set each item as follows.
■ [Dimmer]
Select dimmer mode.
[OFF]: The display and buttons do not dim.
[ON]: The display and buttons dim.
[SYNC ](Default): Turns the dimmer function
on or off when the vehicle light control
switch is turned on or off.
■ [OSD Clock]
Select if you want to display the clock while
watching video, etc.
"ON" (Default)/ "OFF"
■ [Wallpaper Customize]
Changing wallpaper image. (P.46)
■ [Viewing Angle]
If it is hard to see the image on the screen
even, adjust the viewing angle. The smaller
the (negative) value, the more whitish the
image on the screen looks.
"0" (Default)/ "-1"/ "-2"/ "-3"
Ñ Change wallpaper image
1
Touch [Wallpaper Customize] in the
Display screen.
2
Select an image.
*
1
*
1
Select an original image in advance.
!B5A-2304-00b_KWV-M_En.indb 46 2019/04/26 10:56