Setting Up
45English
NOTE
• To cancel the touch panel adjustment, touch
[Cancel].
• To reset to the initial status, touch [Reset].
Ñ Learning function of steering
remote
This function is available only when your
vehicle is equipped with the electrical steering
remote controller.
If your steering remote controller is not
compliant, learning may not be completed
and error message may appear.
1
Touch [Steering Remote Controller] in
the User Interface screen.
Steering Remote Controller Setting
screen appears.
2
Press and hold the steering remote
controller button
NOTE
• You can have the unit learned all buttons
at a time. In that case, press the all buttons
one at a time and after pressing all of them,
touch [Learning completed] in Steering
Remote Controller Setting screen. However,
new functions cannot be learned after this
operation.
3
Touch the function you want to set.
4
Repeat steps 2 and 3 as necessary.
5
Touch [Learning completed].
NOTE
• When changing the function already learned,
press and hold the button you want to change
in step 2 and then touch to select the changed
function from the function list.
• Confirm the contents of the settable function on
the function list. You cannot edit the function list.
• To initialize the contents, touch [Learning
initialisation] of [Steering Remote
Controller] in User Interface screen. After you
touch [Initialise], a confirmation message
appears. Follow the message and complete the
operation.
Special Setup
You can setup Special parameters.
1
Press the [FNC] button.
Popup menu appears.
2
Touch [ ].
HOME screen appears.
3
Touch [ ].
SETUP screen appears.
4
Touch [Special].
Special screen appears.
5
Set each item as follows.
■ [DEMO]
Set the demonstration mode. Default is "ON".
■ [SETUP Memory]
Locks or unlocks the Audio SETUP Memory/
Recall/Clear.
■ [Audio SETUP Memory]
Memorizes the current audio setting.
• Fader/ Balance, Speaker / X’over, Equalizer
(User Preset, SW Level), Position/DTA,
Sound Effect (P.48)
■ [Audio SETUP Recall]
Recalls the memorized audio setting.
■ [Audio SETUP Clear]
Clears the AUDIO SETUP Memory and the
currently memorized audio setting.
!B5A-2304-00b_KWV-M_En.indb 45 2019/04/26 10:56
To Next Page
Loading...
