JVC LT-42C550 - Software Update (over Air Download) (DTV Mode); Software Update (USB) (DTV Mode)

29
5
Customising TV Settings
5. During normal DTV viewing, if the TV detects the latest firmware from the
DTV signal, the Over Air Download screen will appear. Press the
buttons
to select Yes / No for the upgrade procedure.
6. If you select Ye s , the over air download will start. Press the EXIT button if
you want to stop the download and exit the menu.
7. When the download is complete, the TV will return to standby mode. Press
the
button on the right bottom panel under the TV frame or on the
remote control to switch on the TV, the TV will automatically upgrade the
software.
Software Update (Over Air Download) (DTV Mode)
The TV auto detects the latest firmware through the DTV signal and allows you to accept or refuse the firmware upgrade service.
This function may not be available in some countries. Please follow the steps below if applicable.
1. Press the MENU button and then press the
buttons to select the
CHANNEL menu and then press the OK button.
2. Press the
buttons to select Software Update(OAD) and then press
the OK button to confirm.
3. Press the MENU button to return to the main menu.
4. Press the EXIT button to exit the menu.
CHANNEL
PICTURE
SOUND
TIME
OPTION
LOCK
EXIT
EXIT
Auto Tuning
DTV Manual Tuning
ATV Manual Tuning
Signal Information
CI Information
Software Update (OAD) Off
Software Update (USB)
Channel Edit
CHANNEL
Yes No
New software is
Download it now?
TV 1
TS 2
Downloading
20 %
EXIT
During download, please do not turn off or unplug your TV.
8. When the update is complete, the TV will return to standby mode.
9. Press the
button on the right bottom panel under the TV frame or on the
remote control to switch on the TV.
UPGRADING SOFTWARE
PLEASE DO NOT TURN OFF
51%
If you encounter problems after the software update, we recommend that you restore your TV to the factory default
settings. To do this, follow the steps below:
1. Press the MENU button to go to the MAIN menu. Press the
buttons to select OPTION and then press the OK button.
2. Press the
buttons to select Restore Factory Default and then press the OK button. Press the button to select Yes
to reset the setting.
3. The TV settings will be restored to factory default and will be switched off. Follow the First Time Installation steps (refer
to page 21 for details) after you switch on the TV again.
Software Update (USB) (DTV Mode)
This function is only for servicing purposes. Any update information for this TV (if any) will be available at the following website or
contact the our call centre:
• For UK, www.knowhow.com or call our UK Call Centre on 0344 561 1234.
• For Ireland, www.knowhow.ie or call our Ireland Call Center on 1 890 818 575.