20
3 Initial Setup
Turning the TV On for the First Time
1. Connect one end of the RF coaxial cable
to the aerial socket on the wall and
the other end of the cable to the ANT
socket on the back of your TV.
2. Plug the TV into a mains socket and switch on at the mains.
3. In standby mode, press the
button on the remote control to turn the TV on. The LED indicator will flash for a few seconds
then the TV will switch on.
Do not connect the TV to the mains
supply until you have completed all
the connections.
• Always disconnect the TV from the mains socket when not in use for a long period of time.
• The
button on the remote control is only used for switching the TV into standby, it does not disconnect the TV from the
mains power. To completely disconnect the mains power, please remove the mains plug from the mains socket.
Chapter
3
4. The first time you turn the TV on, it will go straight
into the First Time Installation menu. Please ensure
the aerial is plugged in.
Press the
buttons to highlight your language
then press OK.
5. Press the buttons to select your country.
6. Press the
button to highlight Scan Encrypted (pay-
per-view) Channel, then press the
buttons to
select On or Off.
Select Favorite Network Type
In this section you can tell your TV what to tune in.
Digital Aerial is TV through your aerial this is automatically selected.
Cable is if you have cable wired directly into your TV NOT through a set top box
Satellite is if you recieve your TV via a satellite dish.
Analogue is for analogue devices that you may have connected to your TV e.g. a video recorder.
None select this if you don't want to tune in any channels, this could be because you recieve you TV via a set top box that you
have connected via HDMI.
7. Press the
button to highlight Select favourite
network type, then press the
buttons to select
Digital Aerial, Digital Cable, Analogue or None.
Confirm these settings by pressing OK.
HDMI3
HDMI 2
(ARC)
LAN
ANT.
VGA
Optic.OUT
SPDIF
LNB
300mA Max.
13V dc/18V dc
RF coaxial cable
(not included)
RF coaxial cable
with ‘F Type’ connector
(not included)
JVC 43' LED Smart 4K HDR TV LT-43K880 Manual GB GR.indd 20 14/02/2018 14:13
To Next Page
Loading...
Need help?
General
