CommonOperations
TurningOnor Oil the Power
To turn on the unit, press _,_/1STANDBY/ON _"_'_/_'="
so that the standby lamp goes off.
rlrll Jl- rl FJhl
I LIII_1 L I _ I__II _1
To turn off the unit (on standby), press
doll STANDBY/ON again so that the
sttmdby lamp lights up.
A little power is always consumed even while the unit is on
standby.
To switch off the power supply completely, unplug the AC
power cord from the AC outlet.
_When you unplug power or a power
the AC cord if
failure occurs
The clock is reset to " : " soon, while the tuner preset stations
(see page 12) will be erased in a few days.
Settingthe Clock
Before operating the unit any further, first set the clock built
in this unit. You can set the clock whether the unit is on or
off.
On the unit ONLY:
Press CLOCK/TIMER.
rl
L!
The hour digits start flashing on the display.
2 Press I_1_1 or 14141to adjust
the hour, then press SET/
DISPLAY.
I__ h4
I II I
The minute digits start flashing on the display.
• If you wtmt to correct the hour after pressing SET/
DISPLAY, press CANCEL/DEMO. The hour
digits start flashing again.
3 Press I_lP-Ior _ to adjust
the minute, then press
SET/DISPLAY.
rl rlrl_ rll_
LL UL I-_ UI-_
To check the clock time
Press _mdhold SET/DISPLAY for more than
2 seconds while playing any source.
• To return to the source indication, press
SET/DISPLAY.
_ While the time indication appears on the display
If you press a button or turn a control, the time indication returns to
the source indication.
Toadjustthe clockagain
If you have adjusted the clock before, you need to press
CLOCK/TIMER repeatedly until "CLOCK" is selected.
• Each time you press the button, the clock/timer setting
modes chmlge as follows:
G DAILY -- ON TIME -- REC ]
(Daily Timer)
Canceled -- CLOCK -- ON TIME
(Recording Timer)
_If there is a power failure
The clock loses the setting and is reset to " : ." You need to set
the clock again.
Selecting the Sources
To listen to the radio, press FM/AM. (See page 12.)
To play back CDs, press CD I_/ll. (See pages 13 - 19.)
To play back tapes, press TAPE A _ or TAPE B _. (See
page 20.)
To select the external equipment as the source, press AUX.
When you press the play button for a particular source (AUX,
FM/AM, CD _/ll, TAPEA _, mid TAPE B _), the unit turns
on (and the unit starts playing the source if it is ready--
COMPU PLAY CONTROL).
To Next Page
Loading...
