Introduction
We would like to thank you for purchasing one of our JVC products.
Before operating this unit, read this manual carefully and thoroughly to
obtain the best possible performance from your unit, and retain this manual
for future reference.
AboutThisManual
This manual is orgmlized as follows:
• The manual mainly explains operations using the
buttons and controls on the unit. You can also use the
buttons on the remote control if they have the same or
similar names (or marks) as those on the unit.
If operation using the remote control is different from
that using the unit, it is then explained.
• Basic trod common infommtion that is tile same for many
functions is grouped in one place, and is not repeated in
each procedure. For instance, we do not repeat the
information about turning on/off the unit, setting the
volume, chtmging the sound effects, and others, which are
explained in the section "Common Operations" on pages 9
toll.
• The following marks are used in this manual:
Gives you warnings mid cautions to prevent
damage or risk of fire/electric shock.
Also gives you information which is not good
for obtaining the best possible performance
from tile unit.
Gives you information mid hints you had better
know.
Precautions
Installation
• Do not grasp tile control knobs when moving or carrying
tile unit.
• Install in a place which is level, dry trod neither too hot nor
too cold--between 5°C (41°F) and 35°C (95°F).
• Install the unit in a location with adequate ventilation to
prevent internal heat built-up in the unit.
• Leave sufficient disttmce between the unit and the TV.
• Keep the speakers away from the TV to avoid interference
with TV.
I& DO NOT install the unit in a location near heat
sources, or in a place subject to direct sunlight,
excessive dust or vibration.
I
Power sources
• When unplugging from tile wall outlet, always pull tile
plug, not tile AC power cord.
DO NOT handle the AC power cord with wet
hands.
Moisturecondensation
Moisture may condense on tile lens inside tile unit in tile
following cases:
• After starting heating in tile room
• In a damp room
• If the unit is brought directly from a cold to a warm place
Should this occur, tile unit may malffmction. In this case,
leave tile unit turned on for a few hours until tile moisture
evaporates, unplug tile AC power cord, and then plug it in
again.
Others
• Should rely metallic object or liquid fall into tile unit,
unplug tile unit and consult your dealer before operating
any furHler.
• If you are not going to operate tile unit for an extended
period of time, unplug tile AC power cord from tile wall
outlet.
I
If tmything goes wrong, unplug tile AC power cord and
consult your dealer.
I
DO NOT disassemble the unit since there are no I
I
user serviceable parts inside.
To Next Page
Loading...
Need help?
General
