JVC MX-J200 - Getting Started; Connecting Antennas

MX-J200
1-11
Prior to performing the following procedure, remove
the metal cover, the CD changer mechanism
assembly and the front panel assembly.
Disconnect the card wire from connector CN352 on
the cassette amplifier board.
Remove the six screws N attaching the cassette
mechanism assembly.
1.
2.
Prior to performing the following procedure, remove
the cassette mechanism assembly.
Disconnect the card wire from connector CN353 on
the cassette amplifier board.
1.
<Front panel assembly>
Removing the cassette mechanism
assembly (See Fig.25)
Removing the cassette amplifier board
(See Fig.26 and 27)
When reconnecting the card wire, get
it pass through under the harness h on
the DC motor (The Flg.26 shows the
details).
ATTENTION:
Unsolder the soldering i on the flexible wire for the
cassette amplifier board head at the bottom of the
cassette mechanism assembly. Then disconnect the
harness from CN354 on the cassette amplifier board,
and release the harness from the clamp on the upper
part of the cassette amplifier board.
Remove the four screws P attaching the cassette
amplifier board on the bottom of the cassette
mechanism assembly.
2.
3.
Fig.25
Fig.26
Fig.27
N
N
N
P
P
N
Cassette mechanism assembly
Cassette amplifier board
CN352
Cassette amplifier board
CN352
CN353
Cassette mechanism board
DC motor
Harness h
Soldering h
R/P head
(Bottom)
CN354