JVC MX-J200 - Removing the Front Panel Assembly

MX-J200
1-7
Removing the front panel assembly
(See Fig.8 to 13)
Prior to performing the following procedures, remove
the metal cover and the CD changer mechanism
assembly.
Disconnect the card wires from connector CN301,
CN304, CN305 and the harness from CN302 on the
inside of the main board.
Remove the screw E' attaching the earth wire.
Turn over the body and remove the two screws E.
Release the joint b on the bottom and the joint c and
d on both sides of the body using a screwdriver, and
detach the front panel assembly toward the front.
1.
2.
3.
4.
Fig.10
Fig.9
Fig.8
Fig.12
Fig.13
Main board
Front panel assembly
Main board
CN301
CN304
CN305
CN302
CN901A,CN901B
E
Front panel assembly
Joint b
Front panel assembly
Joint c
Front panel assembly
Joint d
(Bottom)
Fig.11
Eath wire
E'