MX-K35V
1-9
Fig.11
Prior to performing the following procedures,
remove the top cover.
Also remove the CD changer unit.
1.
2.
3.
4.
Disconnect the parallel wire and card wire from the
connectors CN901 and CN903 on the power
amplifier board.
Remove the two screws H retaining the front panel
assembly onto the bottom of the body.
Remove the screw J retaining the cassette deck
mechanism and then remove the GND lug b that
comes from the power amplifier board.
Disengage the claws c on both sides at the bottom
of the front panel assembly and then remove the
assembly.
Removing the front panel assembly
(See Fig.11 and 12)
Fig.12
H
J
Power amplifier board
Control/FL board
Claw c
GND lug b
To Next Page
Loading...
Need help?
General
