EN
REMOTE CONTROL OPERATION
To operate the unit with the remote control, point the remote handset at the remote sensor on
the front panel and press the appropriate button on the remote handset.
The remote works best within a range of 6 ~ 7 meters from the front panel and on an angle of
30 degrees. Bright sunlight or room light conditions can interfere with the remote control. If the
remote operation is unsatisfactory or stops working entirely, rst try replacing the remote
batteries, then try reducing the room lighting conditions.
LITHIUM BATTERY INSTALLATION OF REMOTE CONTROL
The remote control includes one CR2025(3V) lithium battery.
To replace the battery, gently push the clasp to the right direction accordingly to the
instruction and then pull out the battery compartment. Take the drained battery out and install
a new lithium battery (CR-2025) in the compartment with the positive polarity unwarded. then
push the compartment back to its position with a “click” sound indicating installation.
BASIC FUNCTION
SWITCHING ON THE UNIT
After connecting the power, press the STANDBY button to turn on the unit. Press the FUNC.
button on unit or remote control to choose TUNER / CD / USB / AUX/ DAB or BLUETOOTH
mode.
NOTE: In CD / USB / AUX / BT mode, when the unit is not providing the main function for 15
minutes, the unit will automatically switch into standby mode. To turn on the unit again, press
STANDBY button or replug the unit.
ESD hints – The product maybe reset or not reset to operation of control due to electrostatic discharge,
just switch off and reconnect again.
TO ADJUST VOLUME
Rotate the VOLUME button on unit or press the VOLUME UP/DOWN key to increase
or decrease volume.
BASS FUNCTION
Press the BASS button on unit to activate the bass eect.
HEADPHONE JACK
For private listening, connect a 3,5 mm headphone (not included) to the HEADPHONE jack.
The SPEAKER will be automatically disabled.
CAUTION: LISTENING AT A HIGH VOLUME OVER A LONG PERIOD IS NOT GOOD FOR YOUR EARS.
FM OPERATION
TUNING IN RADIO STATIONS
1. Press the FUNC. button on unit or remote control to select the TUNER function, this unit is
designed for FM ONLY.
2. Tune to desired station by rotating the TUNING knob on unit or press the /TUN+ or
/TUN- key on remote control, the display will show the band frequency.
Example: FM 97.10 MHz. If the radio receive Stereo signal, “STEREO” will show on the
display.
3. Extend FM TELESCOPIC ANTENNA to its full length and gently move the unit back and
forth to get the best reception, or place the unit in an open location.
To Next Page
Loading...
Need help?
General
