EN
CD/MP3 OPERATION
Discs for Playback
This system can playback all digital audio CD, MP3, nalized digital audio CD-Recordable
(CD-R) discs, nalized digital audio CD-Rewritable (CD-RW) discs and CD-DA format digital
audio CD/CD-R/CD-RW discs.
LOADING A DISC
1. Press the FUNC. button to choose CD mode.
2. Open the CD door. “OPEN” will be shown on the display.
3. Place an audio CD into the tray with the label side facing up.
4. Close the CD door. The display will show “CD--READING”, then the total number of tracks
would be shown and the playback will start from track.
5. To remove the CD, press /MENU/INFO button and open CD compartment lid, grasp the
CD by its edges, and carefully take it out.
Note:
Make sure the disc is stopped before opening the CD door.
To ensure good system performance; wait until the disc tray completely reads the disc before proceeding.
If no disc is loaded into the compartment, or the disc is placed upside down, the display will show “NO DISC“.
PLAYING A DISC
1. The playback starts from track 1 automatically when reading the disc.
2. To pause playback, press /SCAN/SELECT button. The current playing time and “PLAY”
will flash on the display To resume playback, press the /SCAN/SELECT button again.
3. To stop playback, press the /MENU/INFO button, the total number of tracks appears
on the display.
SELECTING A DESIRED TRACK/PASSAGE
To select a desired track
Press the /TUN+ or /TUN- button repeatedly in stop mode or during play until the desired
track appears on the display. It will start play automatically.
To search for a particular passage during playback (track scanning at high speed)
Press and hold the /TUN+ or /TUN- button to scan the current playing track at high speed
until desired passage appears, and then release the button. Playback will start again from this
point.
To select a song which track number exceeds 10 (for USB/MP3 disc only)
To select a song/track which number exceeds 10, press the 10/FOLD./M.+ or /M.- button each
time to skip forward/backward 10 tracks, then press the /TUN+ or /TUN- button to select
desired track.
To Select A Desired Folder (for USB/MP3 that contains more than one folder)
To select a desired folder, press and hold the 10/FOLD./M.+ or /M.- button tune to next/pre-
vious folder.
PROGRAM TRACKS
Programming tracks of disc are possible when playback is stopped. Up to CD 20 tracks /MP3
99 tracks can be stored in the memory in any order.
1. In stop mode, press the PROG./MEM. button to enter program setting, the “MEM” logo and
“P01“ will flash on the display.
To Next Page
Loading...
Need help?
General
