7
Listening to the Radio
Listening to the Radio
Listening to the Radio
To set the AM tuner interval spacing
Before operating the tuner, it is required to select the
appropriate AM space interval used for your area.
• Change the source to AM before the operation.
• AC power supply is required to do the operation while the
System is turned off.
To select 9 kHz interval
To select 10 kHz interval
To select the band (FM or AM)
To tune in to a station
While FM or AM is selected...
The frequency starts changing on the display.
When a station (frequency) with sufficient signal strength is
tuned in, the frequency stops changing.
• When you repeatedly press the button, the frequency
changes step by step.
To stop searching manually,
press either button.
Remote control
SET
Number
buttons
PRESET
UP
PRESET
DOWN
TUNING
DOWN
TUNING
UP
FM/AM
FM MODE
FM/AM DOWN
UP
x4
Main unit
Remote control: Main unit:
Remote control: Main unit:
Main Unit
ONLY
(while holding...)
(while holding...)
FM
AM
FM
AM
RD-HA3[A].book Page 7 Friday, June 1, 2007 5:37 PM
To Next Page
Loading...
Need help?
General
