17
Timer Operations
Timer Operations
Using Sleep Timer
You can set the shut-off time so that you can go to bed
without turning off the System yourself.
1 Specify the time (in minutes).
2 Wait until the set time disappears.
The SLEEP indicator lights up on the display and the
display dims.
To check the time remaining until the shut-off time, press
[SLEEP].
• If you press the button repeatedly, you can change the shut-
off time.
Using Daily Timer
Using Daily Timer, you can wake up with your favorite
music.
• You need to set the built-in clock before using the Daily
Timer (see page 6).
• To exit from the timer settings, press [CLOCK/TIMER] as
required.
• To correct a mis-entry during the process, press
[CANCEL]. You can go back to the previous step.
• When using an iPod as the playback source, activate the
iPod battery charge function (see page 13).
1 Enter the timer setting mode.
• When the clock has not been set, pressing [CLOCK/
TIMER] makes the System enter the clock setting mode
(see page 6).
2 Set the timer as you like.
Repeat the procedure for the following settings until
finished—
1
Set the hour then the minute for the on-time.
*
1
2
Set the hour then the minute for the off-time.
*
1
3
Select the playback source—“FM,” “AM,” “CD,”
“USB MEMORY,” or “iPod.”
4
Select the volume level (from “0” to “35” and
“VOL – –”
*
2
).
*
1
You can also use the number buttons to adjust the
hour and minute.
*
2
If you select “VOL – –,” the volume is set to the
same level as when the System was last turned off.
Once the settings are completed, the Timer setting
information appears in sequence.
3 Prepare the source selected in step 2.
• FM, AM: Select the desired station/channel.
• CD: Set a disc.
• iPod, USB MEMORY: Connect the component.
4 Turn off the System (on standby).
To cancel or reactivate the Timer
Remote control
SET
CLOCK/
TIMER
x
4
CANCEL
SLEEP
STANDBY/ON
Remote
ONLY
10 20 30 60
120
90
150180
Canceled
Remote
ONLY
0:00- 0:00
6:00
TIMER SET
OFF? CANCEL
To reactivate the Timer
To cancel the Timer
RD-HA3[A].book Page 17 Friday, June 1, 2007 5:37 PM
To Next Page
Loading...
