4
Connections
Connecting the Power Cable
AC adaptor
Plug in the System only after all connections are
complete.
• Only use the JVC power cord provided for this System to
avoid malfunction or damage to the System.
• Be sure to unplug the power cord from the outlet when
going out or when the System is not in use for an extended
period of time.
• To use the System on a car battery, use a DC/AC converter
(not supplied).
Carrying the System
• To prevent the System from rolling off, make sure to place
the bottom on the floor or the installation place when
putting the System down.
• Be sure to disconnect the AC adaptor and connection
cables to external components before carrying the System.
Inserting Batteries
Memory backup batteries
Install the memory backup batteries to avoid the preset
stations or clock setting being erased in case of a power
failure or unplugging of the power cord.
• Match the polarity (+ and –) on the batteries with the + and
– markings in the battery compartment.
To operate the System on batteries
• Match the polarity (+ and –) on the batteries with the + and
– markings in the battery compartment.
Do not carry the System with one hand;
otherwise, you may drop it.
To a wall outlet
Power cord (supplied)
AC adaptor
(supplied)
R6 (SUM-3)/AA (15F)
(not supplied)
R20/D (13F)
(not supplied)
RD-HA3[A].book Page 4 Friday, June 1, 2007 5:37 PM
To Next Page
Loading...
Need help?
General
