Listening to DAB stations
To listen to DAB/DAB+
1
Press [TUNER] repeatedly to select
“DAB”.
.
(Press repeatedly)
Main unit
Remote control
2
Select the service.
.
0
When you change the source to DAB for the first
time after plugging in the power cord or after
inserting batteries, the System automatically
performs the scanning for the DAB bands to pick
out available ensembles. It will take a few
minutes depending on the location.
.
0
When the scanning is complete, the System
starts playing the first service of the ensemble
found first.
0
When you move the System or adjust the
antenna position, perform the scanning. Press
and hold [SET] while DAB is selected as the
source.
0
Press [CANCEL] to stop scanning.
0
NOSIGNAL is displayed if scanning is
completed but no signal is found.
To select an ensemble
Press [UP] or [DOWN].
.
0
You can skip to the next/previous ensemble
found in the ensemble scanning.
0
It may take some time to change ensembles.
To search for ensembles
1
Press and hold [UP] or [DOWN].
While you press and hold the button, the
channel changes through all of the
ensembles regardless of their signal status.
2
Release the button at the desired channel
of the ensemble.
To preset services
You can preset up to 30 DAB services manually.
1
Tune in to the service you want to preset.
2
Press [SET].
.
3
Press the number button to select the
preset number you want to store.
0
You can also select by pressing [UP] or
[DOWN].
4
Press [SET] to store the station.
0
To cancel the presetting, press [CANCEL].
0
When you preset DAB services, you can only
preset primary services. If you select a
secondary service to store, its primary service is
stored instead.
To tune in to a preset service
You can select the preset station directly using the
number buttons.
23
ENGLISH
DAB
To Next Page
Loading...
Need help?
General
