JVC RX-430VBK - Page 34

English
Page 29
IMPORTANT:
To operate JVC video components using this remote control:
• Aim the remote control directly at the remote sensor on the VCR or TV, not on the receiver.
After pressing VCR, you can perform the following operations on a VCR:
3 Starts playback
4 Rewinds a video tape
¢ Fast winds a video tape
7 Stops operation
8 Pauses. To resume playing, press 3.
CH+/– Changes channels on a VCR
Without pressing VCR, you can always perform the following:
VCR (in the (Standby/On) section)
Turns on/off the VCR
After pressing TV (in the TV CONTROL section), you can perform the following operations on TV:
CH+/– Changes TV channels
Without pressing TV (in the TV CONTROL section), you can always perform the following:
TV/VIDEO Sets input mode (either to TV or to VIDEO)
VOLUME +/– (in the TV CONTROL section)
Adjusts the volume
TV (in the (Standby/On) section)
Turns on/off the TV
TV
/VIDEO
CH +
CH – 456
123
TV VCR AUDIO
TEST DELAY
PRESET SEA MODE
SURR MODE
CD 7/P 8 9
10 +10
TAPE
FM/AM
SEA
ON/OFF
SURROUND
ON/OFF
VCR TV
TV CONTROL
RM-SR430EU REMOTE CONTROL
–+
VIDEO
ONE TOUCH
OPERATION
VOLUME
–+
CENTER
–+
REAR
CD-DISC
AUDIO
CONTROL
/I
VOLUME
PHONO
–+
MUTE
RX-430VBK(EF)_0022-001A_En 97.4.24, 1:57 PM29